Hewlett Packard Enterprise APIN0207 Wireless Access Point User Manual 207 Series RCSI Guide Rev03说明书用户手册.pdf

Aruba 207 Series Wireless Access Point Regulatory Compliance and Safety Information Guide Introduction This document contains domestic and international regulatory compliance and safety information for the access point. To ensure that this device complies with the regulatory standards for your region, please refer to the sections below.  Electrical and Environmental Specifications  Regulatory Information  Proper Disposal of Aruba Equipment Electrical and Environmental Specifications For additional specifications on this product, please refer to the product data sheet at . All Aruba access points should be professionally installed by an Aruba Certified Mobility Professional (ACMP). The installer is responsible for ensuring that grounding is available and meets applicable national and electrical codes. Tous les points daccès Aruba doivent impérativement être installés par un professionnel agréé. Ce dernier doit sassurer que lappareil est mis à la terre et que le circuit de mise à la terre est conforme aux codes électriques nationaux en vigueur. Electrical  Ethernet:  One 10/100/1000 Base-T auto-sensing Ethernet interface (RJ-45)  Power:  Maximum power consumption (excluding USB):13.5W (PoE) or 12W (DC)  Direct DC source: 12Vdc nominal, +/- 5%  Power over Ethernet (PoE): 802.3af complaint source  Connect only to IEC 60950-1 or IEC 60601-1 3rd edition products and power sources. If a power adapter other than the Aruba-approved adapter is used in the US or Canada, it should be NRTL