System Planning WEDGEV3 local control for remote installation User Manual GlobalTrak Installation Operations Manual说明书用户手册.pdf

GlobalTrak™ Field Setup and Diagnostic Guide System Planning Corporation 1000 Wilson Boulevard Arlington, VA 22209 (703) 351- 8200 GlobalTrak ™ Field Setup and Diagnostic Guide GlobalTrak™ Field Setup and Diagnostic Guide This purpose of the GlobalTrak™ Field Setup and Diagnostic Guide is to: • Test each module as installed for fielding To complete the Field Setup and Diagnostic procedure, the following are necessary: 1. Completed, Configured GlobalTrak installation 2. Laptop computer with RS232 port 3. CMU Field Test Cable 4. CMU Key switch 5. Quad-band GSM phone with Kore SIM card (Optional) 6. Orbcomm Antenna Analyzer (Optional) * 7. Orbcomm Spectrum Analyzer (Optional) * 8. Orbcomm View Software (Optional) * * Note: Items 6, 7, 8 only needed for installations requiring satellite communication Prepared : R. Straz Date : May 31, 2006 Page 2 of 17 GlobalTrak ™ Field Setup and Diagnostic Guide Table of Contents 1.0 Initial Setup 4 Connect the CMU to HyperTerminal4 Capture Diagnostic Information 5 Configure Device for Deployment Error! Bookmark not defined. 2.0 Testing Sensor Module Operation 6 Test Analog Sensor Functionality Error! Bookmark not defined. Test Door Switch Functionality Error! Bookmark not defined. Test GPS functionality 8 3.0 Testing Cellular Communication 9 4.0 Testing Satellite Communication 10 5.0 Final Configuration 11 Appendix A: Field Test Checklist 13 Appendix B: Troubleshooting 16 Problems with Sensor Modules 16 Problems with GSM Com