高压柜操作手册.pdfVIP

Quick instruction of switch gear operation 就地检修程序 Local Switch off procedure for maintenance proposes: 1. 将柜门上的转换开关打到“就地”位置。(1 为就地，2 为自动). Select the bottom from “automatic” to “local” (where “1” is “local”, “2” is “automatic”) 就地local 自动automatic 2. 手动按下分闸按钮，使断路器分闸，并且上门分闸指示灯亮，合闸指示灯灭。Push “switch off” bottom to switch off the circuit breaker; then the “switch-off indicator will turn red. 3. 观察状态显示仪断路器分闸显示，必须如下图所示，或验电后确定无电方可继续操 作。Make sure that the “switch status display device” has the same status as the picture below. 分闸位置，switch- off position A,B,C 三相指示灯灭， Power indication A,B,C were extinguished. 4. 在柜门中间位置插入断路器手车揺柄，逆时针旋转约20 圈，断路器手车从 工作位置摇到试验位置，状态显示仪手车试验位置状态显示；航空抽头联锁 自动解除。Insert the hand tool, turn around at anti clockwise direction about 20 cycles, pull out the circuit breaker from working position to test position. 逆时针转动约20 圈，anti clockwise, around 20 cycles. 5. 在柜中门右下角的六角孔内插入接地刀操作手柄，顺时针旋转约90 °，合 上接地开关，并伴有“咔哒“声。状态显示仪接地刀合位指示。 Insert the hand tools into the earthing connection socket; turn around 90 °at clockwise direction to connect the earth protection. Make sure it there is a sound like “Ka Ta” and the earthing signal activated on the display panel. 接地刀已合上。 Earth protection