Schneider Electric施耐德Symmetra Accessories Rack-Mount PDU (Sheet)安装和用户指南(英语).pdf

APC Symmetra Rack Mount 990-7136 Revision 1 Uninterruptible Power Supply PDU Installation Manual 1. Introduction These instructions describe how to safely install an APC Symmetra Rack Mount PDU. Carefully read these instructions in their entirety before continuing. WARNING! Only qualified service personnel or electricians may perform the following procedure. The electrical terminals exposed in the following procedures will be energized if the UPS is on or plugged in. Make sure the UPS is both unplugged and off. Make sure that the UPS’ DC battery system has been discharged. Refer to Users Manual for instructions. 2. Required Materials and Tools NOTE: Wiring codes and requirements differ from area to area. Be sure to conform to all local electrical requirements when installing and wiring this UPS. The following tools are required for installation: #2 Phillips Screwdriver 3. Installation This section provides step-by-step instructions for removing and installing a PDU to a Symmetra Rack Mount UPS. The images depict a typical PDU installation. 2 1 3.1 Remove Existing Panel 1. Remove the 4 screws that retain the PDU panel as shown in Fig. 3.1 and set aside. 2. Disconnect the two connectors by squeezing the two ears on the connector