Schneider Electric施耐德SpaceLogic VB2x0R VB3x0R Ball Valves with MB6 Series Two-Position Actuators Installation Instructions安装和用户指南(英语).pdf

Installation Instructions | 1 SpaceLogic VB2x0R / VB3x0R Ball Valves with MB6 Series Two-Position Actuators Inspection Mounting Inspect the package for damage. If package is damaged, The valves can be mounted in horizontal or vertical piping. notify the appropriate carrier immediately. If undamaged, When installed in horizontal piping, the actuator must be open the package and inspect the device for obvious dam- above the valve body. It can be tilted left or right but it must age. Return damaged products. not be tilted below 90° from vertical. Requirements Tools (not provided) • Wrench 1 to 1-5/8” (25 to 40 mm) • Pipe wrench according to pipe size • Volt-ohm multimeter Training — Installer must be a qualified, experienced techni- 90˚ cian Horizontal Pipe Other accessories as appropriate Horizontal Plane Notice: • Electrical shock hazard! Disconnect power before 360° installation to prevent electrical shock or equipment damage. • Make all connections in accordance with the electrical wiring diagram and in accordance with national and local electrical codes. Use copper conductors only. • All conductors shall be provided with insulation rated for the highest voltage motor and end switch circuits. • Avoid locations where excessive moisture, corrosive fumes, explosive vapors, or vibration are present. • Avoid electr