PLC控制柜操作说明书.docVIP

PLC控制柜操作说明书 (EG069-08-00) should be conducted in the presence of the supervisor. (7) monitoring instruments and equipment should be checked and corrected after installation, Embedment, and submit calibration reports. Supervision inspection acceptance shall be measured immediately after reading initial values. (8) each measuring point for each observation section within 14 days after planting, to submit their research laid the table control. (9) in the course of construction, all monitoring equipment should be protected, the supervisor requested protection area shall provide protective cover and logo. 10.5.2 surface deformation monitoring (1) surface deformation monitoring point Pier in-situ reinforced concrete Pier, the pier above the ground 1.2m, in undisturbed soil or bedrock (native) deep 1.0~1.5M. (2) the pier top of forced centering plate. (3) when planted, forced centering plate should be horizontal, angle not greater than 4 . 10.5.3 level monitoring point (1) in the standard location monitoring points around the reserve pit formwork, aspect to facilitate in the leveling of the pit shall prevail. (2) the standard markers together with the accessories insert the bottom has not been final set in advance concrete, exposed bottom concrete 1. 主画面 在该画面中给出了整个系统的操作模式，通过触摸不同的按钮，可进入相对应的画面。 1(1 点击 按钮，可进入运转图画面。 1(2 点击 按钮，可进入趋势图画面。 1(3点击 按钮，可进入趋势图画面。 1(4点击 按钮，会跳出Password设定画面，(口令缺省为:******;每次输入口令后，待最后一次操作结束1分钟之后，自动登出)。当正确输入口令后，需再次点击 按钮，将进入参数设定画面。 1(5点击 按钮将复位报警。 1(6点击 按钮将使报警静音。 the accessories insert the bottom has not been final set in advance concrete, exposed bottom concrete r withund the reserve pit formwork, aspect to facilitate in the leveling of the pit shall prevail. (2) the standard markers togethed be horizontal, angle not greater than 4 . 10.5.3 level monitoring point (1) in the standard location monitoring points aropier top of forced centering plate. (3) when planted, forced centering plate shoul situ reinforced concrete Pier, the pier above the ground