Schneider Electric施耐德FD6Q RG-6 Quad Shield Connector, Installation Instructions安装和用户指南(英语).pdf

FD6Q RG-6 Quad Shield Connector Installation Instructions Preparing RG-6 Cable for a Connector Step 1: Cut the cable squarely across the end with the 60-0558-000 cable cutters. Open the jaws of the 490RIO00400 RG-6 installation tool, and set the cable in the trough with the cable end placed against the stop. Parts Required: FD6Q cassette with 10 connectors P/N MA-0329-001 Tools Required: Cable cutters, P/N 60-0558-000 RG-6 installation tool, P/N 490RIO00400 Crimp tool, P/N 60-0544-000 7/16 inch open-end wrench Note: If you are using dual or messenger cable, remove the rib before preparing the cable. Step 2: Release the handle and let the spring hold the tool on the cable. Rotate the stripper with your index finger on the handle until the tool turns freely. Let the spring provide the cutting pressure. Note: Adjust the number of rotations so that the second blade cuts as little of the braid as possible. When the cracking noise stops, the first blade has cut through the shields. Step 3: If the cable is not fully stripped, you may squeeze the jaws of the tool together with your thumb and forefinger. Using light pressure, make one or two revolutions of the tool around the cable until the tool cuts through the cable jacket. Step 4: Open the jaws and remove the cable. Twist off the cable dielectric and jacket by hand. Remove any long braid strands remaining around the prepared cable end. (Long braid strands may indicate that a new blade pack