ISO 13533-2001 石油天然气工业-钻井和采油设备-钻通设备.pdfVIP

INTERNATIONAL STANDARD IS0 13533:2001 TECHNICAL CORRIGENDUM 1 Published 2005-01-15 INTERNATIONAL ORGANIZATIONFOR STANDARDIZATION M ~ W A P O f l H A RO P T A H H I ~ H Rno CTAHflAPTHIAUHH ORGANISATION INTERNATIONALE DE NORMALISATION Petroleum and natural gas industries -Drilling and production equipment -Drill-through equipment TECHNICAL CORRIGENDUM 1 Industries du pétrole et du gaz naturel -Équipements de forage et de production -Équipements à travers lesquels s’effectue le forage RECTIFICATIF TECHNIQUE I Technical Corrigendum 1 to IS0 13533:2001 was prepared by Technical Committee ISOíTC 67, Materials, equipment and offshore structures for petroleum, petrochemical and natural gas industries, Subcommittee SC 4, Drilling and production equipment. Page 19, Table 8, column 6, first line under the header: Replace “84,Owith “795”. Page 20: Replace Figure 6 with the following figure. Notethat the lower ends of the vertical lines defining the dimensions G and N have been modified. ICs 75.180.10 Ref. No. IS0 13533:2001/Cor.l:2005(E) O IS0 2005 -All rights reserved Published in Switzerland IS0 13533:2001/Cor.l:2005(E) Dimensions in millimetres L a Break sharp corner. Figure 6 -Finish machining of type SR ring grooves Page 23, Table 12,first column, fourth under the header: Replace “(31/8)”with “(3 1/16)”. Page 28, Table 16,fiffh column, fourteenth line under the header: Replace “RX 7 3 with “RX 65. Page 36, Table 18,second column, first line under the header: Replace “13 3 with “13,3. 2