组合式开关注塑成型工艺分析及模具设计.pdfVIP

摘 要 在设计开始前先用相关软件对产品进行三维建模，完成组合式开关罩盖塑件的结构 分析，然后选择ABS作为本次产品的材质，确定了本次模具设计最佳分型面位置和模具型 腔腔数，完成了注塑模具浇注系统、脱模机构的设计，最后对模具的冷却系统等相关结 构进行完善，在选择模架的时候，选用了两板模大水口模架，这其中还对型芯型腔的结 构尺寸进行了设计计算，确保整个模具设计过程的标准性与合理性。通过对组合式开关 罩盖注塑模具的设计，全面完整地了解到一套模具的设计制造原理，过程以及方法。 关键词：注塑模；组合式开关罩盖 ；模架；侧浇口 I Abstract Before the design starts, the product is 3D modeled with relevant software to complete the structural analysis of the combined switch cover plastic parts, and then ABS is selected as the material of this product to determine the optimal parting surface position and mold design for this time. The number of mold cavities has completed the design of the injection mold pouring system and demoulding mechanism. Finally, the mold cooling system and other related structures have been improved. When selecting the mold frame, the two-plate mold large nozzle mold frame was selected. The structural dimensions of the core cavity are designed and calculated to ensure the standardity and rationality of the entire mold design process. Through the design of the injection mold of the combined switch cover, we fully and completely understand the design and manufacturing principles, processes and methods of a set of molds. Keywords: injection mold; combined switch cover; mold frame; side gate II 目 录 摘 要I Abstract II 目 录I 1、绪论1 1.1 背景 1 1.2 国内外塑料模具的发展现状1 1.3 选题的背景、设计方法、目的和意义 2 2、塑件的工艺分析3 2.1 塑件成型工艺性分析 3 2.2 ABS工程塑料的性能分析4 2.2.1 ABS塑料参数4 2.2.2 ABS材料注射成型工艺参数:4 3、拟定模具的结构形式和初选注射机6 3.1 分型面位置的确定 6 3.2 型腔数量和排位方式的确定 6 3.3 注射机型号的确定 7 4、 浇注系统的设计 9 4.1 主流道的设计 9