kisssoft Load_spectrum载荷谱实例应用教程.pdfVIP

EES KISSsoft GmbH ++41 41 755 09 54 (Phone) P.O. Box 121 ++41 41 755 09 48 (Fax) Weid 10 ++41 79 821 25 41 (Mobile) 6313 Menzingen h.dinner@EES-KISSsoft.ch Switzerland www.EES-KISSsoft.ch m u r t c e p s d a A gear set in a light commercial vehicle transmission (nominal power of only 35kW) o should be analysed with respect to resulting lifetime using a load spectrum. l h For a test of the gear set, it has to be determined whether all steps in the load spectrum t i w need to be considered or whether certain steps in the load spectrum could be neglected. n In the later case, this would mean that the time needed for testing the gear could be o i reduced. t a If it is found that the gear set has a lifetime higher than the required lifetime, it is of l u interest to find out the maximum permissible torque for which the lifetime would just be c l met. This would then allow the gear set to be used also in another transmission, a c connected to a more powerful engine. e m i 1 Gear data t e f Given a gear set as follows: i l r z1=17, z2=33, mn=3.00mm, beta=14deg RH, alpha=17.5deg, facewidth=20mm, ref profile a e 1.40/0.30/1.10, a=78mm, x1=0.30, n1=1300RpM, Tnom=275Nm G Load spectrum is given as follows: Speed of gear 1 Time Torque of gear 1 650 10h 125% of nominal torque 975 20h 80% of nominal torque 1300 30h 100% of nominal torque 1300 30h 75% of nominal torque 1625 10h 50% of nominal torque Be