沃特世仪器说明书WFC Empower manual.pdfVIP

Using the Waters Fraction Collector III under Empower Control Copyright © Waters Corporation 2010 All rights reserved Copyright notice © 2010 WATERS CORPORATION. PRINTED IN THE UNITED STATES OF AMERICA AND IN IRELAND. ALL RIGHTS RESERVED. THIS DOCUMENT OR PARTS THEREOF MAY NOT BE REPRODUCED IN ANY FORM WITHOUT THE WRITTEN PERMISSION OF THE PUBLISHER. The information in this document is subject to change without notice and should not be construed as a commitment by Waters Corporation. Waters Corporation assumes no responsibility for any errors that may appear in this document. This document is believed to be complete and accurate at the time of publication. In no event shall Waters Corporation be liable for incidental or consequential damages in connection with, or arising from, its use. ii Note: This document is an addendum to the Waters Fraction Collector III Operator’s Guide. Refer to that document for information about hardware. Contents: Topic Page Setting up the WFC III method using the method editor 1-2 Instrument Parameters panel 1-2 Collection parameters tab 1-4 And/Or collections 1-8 Run Samples control panel 1-9 Emergency collection (override) 1-11 What happens when the bed becomes full during a collection? 1-12 Looking at data 1-12 1 Setting up the WFC III method using the method editor This section lists the parameters for setting up the W