基恩士 CV-X 系列 便捷设定手册 控制与通讯篇 PLC链接 (SYSMAC CJ系列) EN.pdf

359GB High-speed, High-capacity Machine Vision System CV-X Series Control/Communication PLC-Link Easy Setup Guide (SYSMAC CJ Series) Contents Easy Setup Guide: Control/Communication PLC-Link (SYSMAC CJ Series) Establishing the PLC-Link (Ethernet PLC-Link) Page 3 Establishing the PLC-Link (RS-232C PLC-Link) Page 7 Outputting the Measured Value/Judged Value (PLC-Link) Page 11 Controlling the Controller (PLC-Link) Page 14 Trademarks Product names, etc. noted in this document are registered trademarks or trademarks of their respective companies. The ™ mark and ® mark have been omitted in this manual. KEYENCE CORPORATION. Vision System Division ‐ 2 ‐ 1. Establishing the PLC-Link (Ethernet PLC-Link) [SYSMAC CJ Series] ✎Checking the Global Settings of the CV-X Series This section describes how to establish the PLC‐Link. [Important] If it fails, establish a one-to-one connection between PLC and CV-X, and follow this manual to configure the settings and check the operations. Confirm that it operates properly, and change settings if necessary. 1 Select [Global] [Communications I/O] [Network] on the controller, and then configure the network (Ethernet) settings on CV-X. Configure the network settings for CV‐X. IP Address: 0