Danfoss丹佛斯Installation Guide Aeroquip Hose Maintenance and Inspection of Hose Assemblies 安装指南.pdf

Installation Guide Aeroquip Performance Products AQPHose Assemblies Hose Maintenanceand Inspectionof Hose Assemblies Hose Maintenance Hose assemblies in operation should be inspected frequently for leakage, kinking, abrasion, corrosion or any other signs of wear or damage. Worn or damaged hose assemblies should be replaced immediately. Assembly Cleaning Clean assembly by blowing out with clean compressed air. Assemblies may be rinsed out with mineral spirits if the tube stock is compatible with oil; otherwise, hot water at +150°F Maximum may be used. Consult Eaton for special cleaning equipment. AssemblyInspection Examine hose assembly internally for cut or bulged tube, obstructions and cleanliness. For segment style fittings, be sure the hose butts up against the nipple shoulder, band and retaining ring are properly set and tight, and segments are properly spaced. Check for proper gap between nut and socket or hex and socket. Nuts should swivel freely. Check the layline of the hose to be sure the assembly is not twisted. Cap the ends of the hose with plastic covers to keep them clean. Hydrostatic Proof The hose assembly should be hydro-statically tested at twice the recommended working Testing pressure of the hose. Test pressure should be held for not more than one minute and not less than 30 seconds. When test pressure is reached, visually inspect hose assembly for any leaks or signs of weakness and any movement of the hose fittingin relation to the hose. Any of these defects are cause for rejection.