Danfoss丹佛斯Installation Guide Aeroquip AQP Hose Routing and Installation 安装指南.pdf

Installation Guide Aeroquip Performance Products AQPHose Assemblies Hose RoutingandInstallation Hose RoutingandInstallation Under pressure, a hose may change If a hose is installed with a twist in When hose lines pass near an exhaust in length. Always provide some it, operating pressures tend to force manifold or other heat source, they slack in the hose to allow for this it straight. This can loosen the fitting should be insulated by a heat resistant shortening or elongation. (However, nut. Twisting can cause reinforcement boot, firesleeve or a metal baffle. In any excessive slack in hose lines may separation, and the hose could burst application, brackets and clamps keep cause poor appearance.) at the point of strain. hose in place and reduce abrasion. For installations where abrasion to the hose cover cannot be prevented with the use of clamps or brackets, a steel protective coil or abrasion resistant sleeve should be placed over the hose. At bends, provide sufficient hose so In applications where there is When 90° adapters were used, this that it does not have a bend radius considerable vibration or flexing, assembly became neater-lookingand less than its recommended minimum