Danfoss丹佛斯Installation Guide Aeroquip AQP Hose Fittings Torque Specifications 安装指南.pdf

下载文档

3
0
约7.81千字
约 2页
2023-05-08 发布于广东
举报
版权申诉
保障服务

Danfoss丹佛斯Installation Guide Aeroquip AQP Hose Fittings Torque Specifications 安装指南.pdf

1、原创力文档（book118）网站文档一经付费（服务费），不意味着购买了该文档的版权，仅供个人/单位学习、研究之用，不得用于商业用途，未经授权，严禁复制、发行、汇编、翻译或者网络传播等，侵权必究。。
2、本站所有内容均由合作方或网友上传，本站不对文档的完整性、权威性及其观点立场正确性做任何保证或承诺！文档内容仅供研究参考，付费前请自行鉴别。如您付费，意味着您自己接受本站规则且自行承担风险，本站不退款、不进行额外附加服务；查看《如何避免下载的几个坑》。如果您已付费下载过本站文档，您可以点击这里二次下载。
3、如文档侵犯商业秘密、侵犯著作权、侵犯人身权等，请点击“版权申诉”（推荐），也可以打举报电话：400-050-0827(电话支持时间：9:00-18:30)。

Danfoss丹佛斯InstallationGuideAeroquipAQPHoseFittingsTorqueSpecifications安装指南用户手册产品说明书使用说明文档安装使用手册

Installation Guide Aeroquip Performance Products AQPHose Fittings TorqueSpecifications Torque Specificationsfor AluminumFittings One of the most frequently asked questions is how tight should the connection between the fitting and the adapter be The correct answer is to follow the specification guidelines listed below. This will give the proper tightness to allow for a good seal, but prevents damage to the fitting by over torque. Torque Specification Guidelines AlternateTightening Method One Nut Minimum Maximum Flats Method Number of Size Torque1 Torque1 Size Hex Flats Rotations -02 50 80 Here are the steps for an -04 11⁄2 to1 3⁄4 -03 70 105 excellent method of -06 1to 11⁄2 -04 100 140 tightening. Anyone can tell -08 11⁄4 to1 3⁄4 -05 130 180 if the joint was tightened -10 11⁄4 to1 3⁄4 -06 150 195 and how much. -12 1to 11⁄2 -08 270 350 1.Tighten the nut by hand -16 3⁄4 to1 -10 360 430 until it bottoms the seats. -20 1⁄2to 3⁄4 -12 460 550 -24 1⁄2to 3⁄4 -16 700 840