ANSI AWWA C105 A21.5-18 Polyethylene Encasement for Ductile-Iron Pipe Systems 球墨铸铁管系统用聚乙烯外壳.pdf

ANS l/AWWA C105/ A21.5-18 (Revision of ANSl/AWWA C105/A21.5·10) ＇~® American Water Works Association Dedicated to the Worlds Most Important Resource® AWWA Standard 一－－－－－二 Polyethylene Encasement for Ductile-Iron Pipe Systems Effective date: December 1, 2018. First ed ition approved by AWWA Board of Directors in 1972. This edition approved June 9, 20 18. Approved by Amer ican National Standards Institute Sep. 21, 2018. .~. ISTANDARD S军如 I Since 1881 @ c。PY句ht®2018Am回国nWater Works As四ciati。n All 阳ghts Reserv国 AWWA Standard This document is an American Water Works Ass。aation (AWWA) standard. It is n。t a specificati。n AWWA standards describe minimum requirements and d。 not contain all of 由e engineering and administrative information n。rmally c。n日ined in speci flcati。ns. The AWWA standards usually contain opti。ns that must be evaluated by 由e user 。f the standard. Until each 。ptional feature is speci白ed by 由euser. 由e product or service 』s not fully defined . AWWA publication of a standard d。es not constitute endorsement 。f any product or produ口type. nor does AWWA test, certi fy， 。r approve any product The use of AWWA S阳ndards is ent irely volu ntary This standard does n。t supersede or 旧ke precedence over or displace any applicable law, regulation. or codes of any g刷ernmental authority AWWA standards are intended to represent a consensus 。f 白ewater industry that the product described wi ll provide sat1sfact。ry service When A叭/WA revises or withdraws 刷I s standard, an official noti ce 。faction will be placed in the Official Notice section ofJoυrnolAWWA. The action becomes effective o