ASTM D3816 D3816M-96(2020) 压感胶带的水渗透率的标准试验方法.pdf

This international standard was developed in accordance with mternationally recogmzed prmciples on standardization established m the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. /H ~ 11!¥ Designati。n: D3816/D3816M - 96 (Reappr。ved 2020) ？由直？一 Standard Test Method for Water Penetrati。n Rate of Pressure-Sensitive Tapes 1 This standard is issued under the 自xed designation D38 I6/D38 I6M; the number immediately following the designation indicates the year of original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval A superscript epsilon （ε） indicates an editorial change since the last revision or reapproval. This standard has been 叩•pmvedf01 use by agencies of the U丘 Depm tment of Defense. 1. Scope 3. Terminoloy 1.1 This test method provides one procedure for measuring 3.1 De,卢nitions General terms in this test method are the water p巳n巳tration rate of 2 in. or wider pressure sensitive defined in Terminology D996 . tape. 4. Summary of Test Method 1.2 The values stated in either SI or inch-pound units are to be r巳garded separat巳ly as standard. The values stated in each 4.1 The pressure-sensitive tape to be tested is secured by its adhesive to a test cup containing a desiccant. Th巳 assembl