Seagate希捷外置网络BlackArmor NAS 400 BlackArmor NAS 440 420 Hard Drive Replacement Procedures.pdf

BlackArmor® NAS 440/420 Hard Drive Replacement Procedures Follow these steps to replace a hard drive in the BlackArmor® NAS 440/420 server. You may also use these instructions to replace a damaged hard drive carrier. NOTE: Only Seagate hard drives can be used for replacement. Failure to use Seagate replacement parts can and will forfeit the warranty period of the BlackArmor NAS 440/420. WARNING: ESD Precautions Electrostatic discharge (ESD) can damage the processor, hard drives, main board, memory modules (RAM), and other BlackArmor components. Always observe the following precautions before replacing a hard drive: ● Do not remove a component from its protective packaging until you are ready to install it. ● Do not touch the component pins, leads, or circuitry. ● Wear a wrist grounding strap and attach it to a metal part of the system before handling components. If a wrist strap is not available, maintain contact with the system throughout any procedure requiring ESD protection. ● Keep the work area free of nonconductive materials, such as ordinary plastic assembly aids and foam packing. Removing a Hard Drive 1 . Open the BlackArmor Manager Web interface. 2 . In the menu bar, select Storage, and then click Disk Manager. 3 . Beside the failed disk drive, click the Safely Remove Disk icon, and then click OK. 1 . Open the front panel of the server. 2 . Locate the failed hard drive. Ensure that there is no activity on the drive by checking its LED—it should not be illuminated. WARNING: Never remove more than one drive at a time. Failure to do so will result in data loss. ©2009 Seagate Technology LLC 1 3 . Press down on the orange button to release the failed drive from the server. If the server is powered on, wait until the drive stops spinning (approximately one minute) before continuing. 4 . Holding the handle, gently slide the hard drive partially out of the server until you can get a firm