【codesys2.3培训_WAGO英文原版】Module_8_Exercises_landscape format.pptVIP

EXERCISE 1Write a program with the following functionFirst program in FBDS3S1S2K0 EXERCISE 2Write a program with the following functionFirst program in CFCS3S1S2K0 EXERCISE 3Write a program with the following functionFirst program in LDS3S1S2K0 EXERCISE 4Write the program in FBD or CFCProgram in FBD or CFCS1S8S5K1S4S3S2S6S7 EXERCISE 5Now please program the circuit diagram in LDProgram in LDS1S8S5K1S4S3S2S6S7 EXERCISE 6Add an ON delay for output K2 with a 4.75 s delay time to the program from Exercise 4Program with a TimerS1S8S5K1S4S3S2S6S7K1Timer1K2Timer1 EXERCISE 7With the aid of two “TP” function blocks, program a flashing light that flashes at a clock rate of 100 ms.Flashing LightTPTPtimetimeQ EXERCISE 8Parking Garage EXERCISE 9Conveyor BeltGenerate a PLC_VISU with the elements depicted.The system is switched using S1 to “RUN” and using S2 to “STOP”.Using S3 simulates the “light sensor” that is used for counting the parts.The “engine” runs as long as the counter has not reached the value 5 and the system is set to “RUN”. The counter could be reseted by using S4 (container changed). EXERCISE 10BoilerRealize a boiler control by means of which a water boiler can be filled and heated. The system should be started/ stopped using a start/ stop button. At a filling level of 4000 liters, the valve should be closed. The fill level is determined using a 0-10 V module. At a temperature above 25°C, boiler heating should be stopped. The temperature is determined by means of a thermocouple. EXERCISE 10.1In order to protect the burner, it should be switched via a hysteresis function. Addition25°C20°COffOn30°C 恭祝马到成功