Buffalo巴法络Network Video Recorder (NVR) TS5200DS User Guide with Axis Network Cameras (PDF)说明书用户手册.pdf

User Guide with Axis Network Cameras 02 2014.09 Contents Chapter 1 Getting Started 2 About the Manual 2 How to Setup 2 Chapter 2 Setup and Configuration 3 Chapter 3 Network Camera Connection 5 Chapter 4 AXIS Camera Companion Usage 6 Minimum Client Computer Requirements 6 Download 6 Installation6 Setup 9 How to Use 14 1 Chapter 1 Getting Started About the Manual This manual describes how to use AXIS Camera Companion version 2.15.027 with a compatible TeraStation or LinkStation. Depending on the software version, the screen layout may be different. How to Setup To use Axis network cameras, set up the environment as shown below. 1 Set up the TeraStation or LinkStation. 2 Connect a network camera to the network. 3 Download the latest AXIS Camera Companion. 4 Configure AXIS Camera Companion. 2 Chapter 2 Setup and Configuration First, set up your LS420DS series LinkStation or TS5200DS series TeraStation by following their respective quick setup guide and configure them to be used with AXIS Camera Companion. We recommend using the manual of the LinkStation or TeraStation as a guide when configuring the unit to work with network cameras. The user manuals are available at the following links: For LS420DS: http://d.buffalo.jp/LS420DS/ For TS5200DS: http://d.buffalo.jp/TS5200DS/ Use with Latest Firmware Before you start, make sure the latest firmware for your LinkStation and TeraStation has been installed. If the LinkStation or TeraStation is connected to the network and a new firmware version is available, a message will be displayed in either NAS Navigator2, the LCD display, or Settings. If displayed, log in to Settings