Danfoss丹佛斯VLT® Control Panel LCP 23 IG 安装指南.pdf

Installation Guide VLT® Control Panel LCP 23 VLT® AutomationDrive FC 360 1 Introduction and Installation 1.1 Description This installation guide explains how to install the VLT® Control Panel LCP 23 for VLT® AutomationDrive FC 360. 1.2 Item Supplied • VLT® Control Panel LCP 23 (code number: 132B0801). 1.3 Safety Precautions Only qualified personnel are allowed to install the LCP 23 described in this installation guide. For important information about safety precautions for installation, refer to the drives operating guide. W A R N I N G DISCHARGE TIME The drive contains DC-link capacitors, which can remain charged even when the drive is not powered. High voltage can be present even when the warning indicator lights are off. Failure to wait the specified time after power has been removed before performing service or repair work could result in death or serious injury. - Stop the motor. - Disconnect AC mains, permanent magnet type motors, and remote DC-link supplies, including battery back-ups, UPS, and DC-link connections to other drives. - Wait for the capacitors to discharge fully. The minimum waiting time is specified in the table Discharge time and is also visible on the nameplate on top of the drive. - Before performing any service or repair work, use an appropriate voltage measuring device to make sure that the capacitors are fully discharged. Table 1: Discharge Time for FC 360 Power range [kW (hp)] Voltage [V] Enclosure size Minimum waiting time (minutes) NO HO 3x400 J1, J2, and J3 – 0.37–7.5 (0.5–10) 4 3x400 J4, J5, J6, and J7