Brinno缩时拍MAC200 DN CAMERA FIRMWARE说明书用户手册(1).pdf

Firmware Motion Activated Camera Upgrade MAC200 Procedure version EN A1 Before doing rmware upgrade process, please follow below steps and unzip the rmware upgrade package. Step 1 Ensure your camera is powered down and remove SD card from the camera. Then insert the SD card into your computer. Power OFF Step 2 Copy and save the le MAC200FW.BIN into 200MAC00 folder in the SD card (200MAC00 folder DCIM should locate in the DCIM folder) ** If your SD card doesn’t have a folder named 200MAC00 in the 200MAC00 DCIM folder, please create those folders by yourself! MAC200FW.BIN Step 3 Insert the SD card into the camera. Insert SD card Step 4 Power on the camera. Power ON Step 5 After the upgrade tool has fully loaded, you will see an Updating Warning message on LCD screen, it means that the camera is updating rmware. Please ! do not power o the camera when you see the warn- ing!! Just wait until the upgrade is completed! DO NOT POWER OFF Done Once completed the upgrade, verify your new ver- sion to make sure the upgrade was successfully com- pleted. Finished ! Please do not TURN OFF power or REMOVE SD card when camera is updating rmware as that will damage the camera! Supports: customerservice@ 2014.08.28