FLUKE Calibration福禄克计量校准RPM4 Reference Pressure Monitor RPM4™ Rack Mount Kit Installation Instructio.pdf

RPM4™ Rack Mount Kit P/N 401929 INSTALLATION INSTRUCTIONS RACK MOUNT KIT, P/N 401929, INCLUDES FIGURE QTY PART NO CALLOUT DESCRIPTION 1 123699 1 Front panel 2 124155 2 Side bracket 4 100972-Z 3 M4 hex nut 4 102668-Z 4 M4 split lock washer 4 101016-Z 5 M4 x 12 SHC screw 4 100918-Z 6 M4 flat washer 1 123703 7 Rear support bracket 1 123764-01 8 Foam gasket 4 103448-Z N/A M3 x 12 self-tapping screw INSTALLATION INSTRUCTIONS Figure 1. Rack Mount Kit  Remove the four feet from the bottom of the RPM4™ by removing the screw and then removing the foot. Replace the screw with the shorter M3 x 12 self-tapping screw included in this kit. Repeat for the other three feet. Place one side bracket (2) on each side of the RPM4. Position each bracket with the front panel attachment flange (flange with two holes) facing the front of the RPM4. Attach the front panel (1) to the side brackets (2) using four M4 split lock washers (4) and four M4 hex nuts (3). Recommended torque is 3 Nm. Figure 2. Rear Support Bracket and Foam Remove adhesive backing from foam strip (8). Adhere the foam strip to the rear support bracket (7), centering the foam as shown in figure 2.  Attach the rear support bracket (7) to the s