FLUKE Calibration福禄克计量校准PG7302 Piston Gauge High Pressure Filter Kit Instruction Sheet (654.23 KB)说明.pdf

HIGH PRESSURE FILTER KIT P/N 402376 INSTRUCTION SHEET HIGH PRESSURE FILTER KIT, INCLUDES: DESCRIPTION QTY PART NO. High Pressure Filter 1 103739 Instruction Sheet 1 560083 INTRODUCTION Figure 1: High Pressure Filter The High Pressure Filter (see Figure 1) is intended for use with the PPCH Hydraulic Pressure Controller. The filter connects to either a stand alone PPCH (see Figure 2) or to a PPCH with a PG7302 (see Figure 3). This document contains instructions for connecting the fittings and tubing for optimal proper performance. The filter has DH500 fittings at either end. This is the same type of fitting that is on the PPCH TEST port. It is important that the filter be positioned and oriented as shown in Figure 2 and Figure 3. In particular, the filter should not be installed between the PPCH and the PG7302 piston gauge. CLEANING OR REPLACING THE FILTER Depending on operating conditions, the filter may become Figure 2: Installation of filter on stand alone PPCH. filled with contaminants from the test circuit. This means the filter is doing its job. If the filter shows signs of reduced flow, the filter should be replaced with a new filter. Alternatively the filter may be backwashed to remove contaminants, however backwashing must be done very carefully to avoid introducing contaminants to the PPCH. The safest backwash method is to disconnect the inlet (DUT side) of the filter and use the PPCH prime function to run oil throug