农机驱动桥的结构与维修—驱动桥的拆装与调整（农机底盘结构与维修课件）.pptx

3.5 驱动桥的调整小锥齿轮轴垫片厚度的确定 Using a micrometer, measure the H1 distancebetween the crown wheel axis and major base of pinion (internal ring of rear bearing).用测微计测量差动器侧伞齿轮到锥齿轮底部（后轴承内环）H1的距离Bevel Pinion Positioning小锥齿位置 The thickness of adjuster ring S is given by调整环 S 厚度由下式计算出:S = H1 + Sp - H3Where其中: H1 is distance measured H1为测量出的距离Sp is the test ring Sp为调整环H3 = H2 ± CH2 = 145.5 mm (nominal distance)C is the correction value stamped on the pinionCorrection value CAdjuster ring调整环 SBevel Pinion Positioning小锥齿位置 Pinion Shaft Tapered Bearings Adjustment小齿轮轴锥形轴承调节Fit the bevel pinion, complete with relative parts.连同相关零件一起装配小锥齿Tighten the adjuster nut, whilst rotating the pinion shaft to correctly position the bearings.拧紧调整螺母，同时旋转小齿轮轴将轴承的位置调整正确The rolling torque corresponds to a force (measured with a spring balance) of 8.6 ÷ 17.2 N.滚轴扭矩为（用弹簧秤测出） 8.6 ÷ 17.2 NMeasure the rolling torque with a cord wrapped around the low gear Pinion Shaft Tapered Bearings Adjustment小齿轮轴锥形轴承调节Fit the bevel pinion, complete with relative parts.连同相关零件一起装配小锥齿Tighten the adjuster nut, whilst rotating the pinion shaft to correctly position the bearings.拧紧调整螺母，同时旋转小齿轮轴将轴承的位置调整正确The rolling torque corresponds to a force (measured with a spring balance) of 8.6 ÷ 17.2 N.滚轴扭矩为（用弹簧秤测出） 8.6 ÷ 17.2 NMeasure the rolling torque with a cord wrapped around the low gear Clearance Between Satellite and Planetary Pinion Teeth行星齿轮与行星齿轮齿间间隙 LHM Axial movement of the LH planet左侧行星齿轮轴向运动 RHM Axial movement of the RH planet右侧行星齿轮轴向运动 H1 Distance between housing and planet (with planet touching the satellite) 壳体与行星齿轮间距离 H2 Distance between housing and planet (with planet touching the housing) 壳体与行星齿轮间距离 LHS Shim for LH planet左侧行星齿轮垫片 RHS Shim for RH planet右侧行星齿轮垫片 0.30 Nominal backlash (0.25 TL-70A) mmLHM/RHM = H1 - H2LHS/RHS = LHM/RHM - 0.30 Crown - Wheel AdjustmentMount the Crown - Wheel assembly together with left and right supports. By tool 50027, bring the left and right ring nuts in contact with the be