福禄克Fluke-190-102 S ScopeMeter®彩色数字示波表190 Series II 内存易失性声明.pdf

Instrument Security Procedures Model: 190-062, 190-102, 190-104, 190-202,190-204, 190-502, 190-504 Product Name: ® 190 Series II ScopeMeter Instrument Description: ScopeMeter® Test Tool Memory Description: The 190 Series II ScopeMeter® test tool has these memory devices: 1. D4000 Controller “Spider”. Contains a mask ROM 4k x 32 with the initial program that holds the operating code for the product and a RAM 1k x 32 to temporarily store stack values for computing actions. 2. D4001: 1x 4 Mb SRAM. Memory is used to store the actual screen and instrument setup. 3. D5000, D5002, 2x 64 Mb Flash EEPROM Non-volatile memory used to store: - operating code (instrument firmware) for the product - calibration constants - user-saved screens and instrument setup information 4. D5001, D5003: 2x 8 Mb SRAM memory used to store the actual screen and instrument setup. Memory Cleaning Instructions: The operating code (instrument firmware) stored in D5000, D5002 can be read with dedicated remote interface commands (only available for use by Product Development). The instrument firmware can be loaded selectively with firmware downloads that are distributed through the Fluke website. Fluke Service Centers can load firmware and configure the instrument with Service tools.  Caution The upgrade tool will erase all saved screens and instruments setups. Calibration constants stored in D5000, D5002 can be read with special remote interface commands (only available for use by Fluke Product Development or Fluke Service Centers). The calibration constants are generated when the test tool