电气安装工程施工方案.docxVIP

电气安装工程施工方案 Electric n Project n Plan 1.1 Steel Pipe n Project 1.Material Requirements The wall thickness of the conduit should be even。with no cracks。burrs。or dents。and the product should have a certificate of conformity. The conduit clamps should be threaded and clear。with no loose or missing zinc plating。smooth and burr-free at both ends。and have a certificate of conformity. The locking nuts and root nuts should be intact and undamaged。with a certificate of conformity. Copper bushings should be used as protective covers。which should be intact and undamaged。and have a certificate of conformity. The materials of round steel。flat steel。and angle steel should comply with relevant nal ns。with intact zinc plating and a certificate of conformity. 2.Operating ns For concealed conduit n。the horizontal lines of each floor and the wall thickness lines should be marked。and coordinated with the civil n。For cast-in-place concrete slab piping。it should be coordinated with civil n according to the ns and ns on the n drawings before the bottom layer of rcement is tied and the upper layer of rcement is not tied。The vertical pipes are installed in n with the wall n. For exposed conduit n。it should be coordinated with the n of embedded parts in civil structures。and installed after the n of civil r n paint and coating。Conduits installed using n tubes must be installed after the plastering work of civil n is completed. 3.n Process For wiring conduits installed in dusty and humid places。the joints of the conduit mouth and conduit should be sealed. The concealed conduit should be embedded in the wall or concrete。and the distance from the wall surface should not be less than 15mm. The buried electrical conduit should not pass through equipment ns。and should be sleeved when passing through building ns. The bending radius of the exposed conduit should not be less than 10 times the outer diameter of the conduit. The conduit ns should be tight。the conduit mouth should be smooth。and the prote