超高性能混凝土的配制与测试分析.pdfVIP

试验研究 Experimental Research 超高性能混凝土的配制与测试分析 1,3 2 1,3 1,3 1,3 张　磊 　高　芬 　彭罗文 　雷　强 　艾明星 1. 中国建筑科学研究院有限公司 北京 100013 2. 北京化工大学 北京 100029 3. 中建研科技股份有限公司 北京 100013 摘 要：在相同扩展度的条件下，以水泥、硅灰、粉煤灰、矿粉、石英砂和钢纤维为原材料制备超高性能混凝 土，通过测试混凝土的抗压强度、抗折强度、静力受压弹性模量和收缩率，研究不同水胶比、胶凝材料和钢纤 维掺量对混凝土性能的影响。结果表明：当超高性能混凝土中各材料掺量为水泥850kg/m 、硅灰150kg/m 、粉3 3 煤灰150kg/m 、石英砂1000kg/m 、钢纤维235kg/m 、水161kg/m 、减水剂30kg/m 时，混凝土的抗压强度为3 3 3 3 3 -6 144.8MPa、抗折强度为27.8MPa、静力受压弹性模量为46100MPa、收缩率为211.6×10 ，混凝土性能最佳。 关键词：超高性能混凝土；钢纤维；抗折强度；收缩率 Preparation and Test Analysis of Ultra-high Performance Concrete Abstract: Under the same slump-flow, the ultra-high performance concrete was prepared with cement, silica fume, fly ash, mineral powder, quartz sand and steel fiber as raw materials. By testing the compressive strength, flexural tensile strength, elastic modulus under static compressive and shrinkage of concrete, the influence of different water-binder ratio, cementitious material and steel fiber content on concrete performance was studied. The results show that the compressive strength of concrete is 144.8 MPa, flexural strength is 27.8 MPa, static compressive modulus of elasticity is 46100 MPa, -6 3 and shrinkage is 211.6×10 when the content of each material of ultra-high performance concrete is 850 kg/m of cement, 3 3 3 3 3 150 kg/m of silica fume, 150 kg/m of fly ash, 1000 kg/m of quartz sand, 235 kg/m of steel fiber, 161 kg/m of water, and 3 30 kg/m of water reducer, the concrete perf