em模拟微波办公培训.pdf

EM Simulation • EM simulation setup has changed in 7.5. – EM uses drawing layers. • Case 1: Draw and Simulate a Structure in the EM Environment. • Case 2: Using a Layout Created in the EM Environment in normal layout. • Case 3: Importing DXF and GDSII Layouts Into EM. • Case 4: Extracting layout from the Schematic Layout. 2 EM Simulation The EM Environment Step 1: Open up the project 4Layer_PCB_Start.emp. This is the EM Socket. Projects go in here. To create a project - RC on EM Structures. The various EM simulators - we are using EMSight. 3 EM Simulation EM Enclosure Settings The Enclosure controls many of the important features of EM: • X and Y box dimensions, and grid size. •Bulk material properties. •Dielectric Layer Setup. •The conducting line properties - layer, conductivity, and thickness. •EM Layer Map (Used when working with schematic layout and artwork cells. Note: Later we will be seeing the Stackup Element for extraction. It is almost the same as the Enclosure (with some extra features). 4 EM Simulation EM Enclosure Settings - 2 Enclosure Sets the x and y dimensions of the enclosing box. The height (z) we set later. Sets the grid in the x and y directions. You want the box size a whole number of cells. 5 EM Simulation Grid Size Tips • Lines should be 3 to 5 cells wide. – Edge couplers mi