技术要求中英对照.pdfVIP

. I. SUMMARY OF NOTES 技术要求汇总 SHEET METAL 钣金： NOTES 技术要求（喷涂）： 1. INNER BENDING RADII TO BE R_ UNLESS OTHERWISE SPECIFIED 未注内折弯圆角R_ 2. REMOVE ALL SHARP EDGES AND CORNERS 去除毛刺锐边 3. DIMENSIONS ARE TO THEORETICAL SHARP CORNERS 尺寸标注为到理论尖角的尺寸 4. FINISH: POWDER COATING 表面处理： 喷粉 NOTES 技术要求（镀锌）： 1. INNER ENDING RADII TO BE R_ UNLESS OTHERWISE SPECIFIED 未注内折弯圆角R_ 2. REMOVE ALL SHARP EDGES AND CORNERS 去除毛刺锐边 3. DIMENSIONS ARE TO THEORETICAL SHARP CORNERS 尺寸标注为到理论尖角的尺寸 4. FINISH: Fe/Zn_ /D (GB/T 9799, ISO20811) 表面处理：Fe/Zn_ /D (GB/T 9799, ISO20811) NOTES: RECOMMEND Fe/Zn5 /D FOR 120H SALT FOG TEST REQUIREMENT AND Fe/Zn12 /D FOR 192H SALT FOG TEST REQUIREMENT PER ASTM B117.注：对于按照ASTM B117 要求，120 小时盐雾试验要求的 推荐电镀Fe/Zn5 /D，192 小时盐雾试验要求的推荐电镀Fe/Zn12 /D. 铜母排COPPER BUSBAR: NOTES 技术要求 (镀锡)： 1. INNER ENDING RADII TO BE R_ UNLESS OTHERWISE SPECIFIED 未注内折弯圆角R_； 2. FINISH: BRIGHT TIN PLATING PER ASTM B545 按照ASTM B545 规定镀亮锡 TIN PURITY: 99.0%, GRADE: B BRIGHT, CLASS: B, THICKNESS: 5 TIN PURITY: 99.0%, GRADE: B BRIGHT, CLASS: B, THICKNESS: μm 锡纯度：99%，等级：电镀亮锡，类型：B，厚度 μm; 3. OTHER NON PLATING SURFACE TO COVER BY HEAT SHRINKABLE TUBING 其余非指定电镀区域用批准的高压热缩套; 精选范本 . 4. COPPER CONDUCTIVITY SHALL BE NO LESS THAN 97%IACS 铜导电率不低 于97% IACS. NOTES 技术要求(镀银)： 1. INNER ENDING RADII TO BE R_ UNLESS OTHERWISE SPEICIFIED 未注内折弯圆角R_； 2. FINISH: SILVER PLANTING PER ASTM B700 表面处理：按照ASTM B700 镀银 SILVER PURITY: TYPE3 98.0%, GRADE: B BRIGHT, CLASS: N, THICKNESS: 5μm 银纯度：3 型98%，等级：亮银B 级，类型：N，厚度5 μm 3. OTHER NON PLATING SURFACE TO COVER BY HEAT SHRINKABLE TUBING 其余非指定电镀区域用批准的高压热缩套。 4. COPPER