温度传感器分析和总结.docxVIP

#includereg52.h #define uchar unsigned char #define uint unsigned int uint tem; sbit ds=P2^2; sbit dula=P2^6; sbit wela=P2^7; uchar code table[]={0x3f,0x06,0x5b,0x4f, 0x66,0x6d,0x7d,0x07, 0x7f,0x6f,0x77,0x7c, 0x39,0x5e,0x79,0x71}; uchar code table1[]={0xbf,0x86,0xdb,0xcf, 0xe6,0xed,0xfd,0x87, 0xff,0xef,0x77,0x7c, 0x39,0x5e,0x79,0x71}; void delay(uint x) { //带小数点的编码 uint i,j; for(i=x;i0;i--) for(j=110;j0;j--) ; } void dsreset() { uint i; ds=0; i=103;while(i0) i--; ds=1; i=4;while(i0) i--; } bit read_bit() { uint i; bit s; // ds=1; // i++; ds=0; i++; // i++;i++; ds=1; i++;i++; s=ds; i=8;while(i0) i--; return (s); } uchar read_byte() { uchar i,j,s; s=0; for(i=8;i0;i--) { j=read_bit(); s=(j7)|(s1); } return (s); } void write_byte(uchar s) { uint i,j; bit test; for(i=0;i8;i++) { test=s0x01; s=s1; if(test) { } else { } } } ds=0; j++;j++; ds=1; j=8;while(j0) j--; ds=0; j=8;while(j0) j--; ds=1; j++;j++; void tem_change() { dsreset(); delay(1); write_byte(0xcc); write_byte(0x44); } uint get_data() { float tem1; uchar h,l; dsreset(); delay(1); write_byte(0xcc); write_byte(0xbe); l=read_byte(); h=read_byte(); tem=h; tem=8; tem=tem|l; tem1=tem*0.0625; tem=tem1*10+0.5; return tem; } void dis_tem(uint t) { uint g,s,x; s=t/100; g=t%100/10; x=t%10; dula=1; P0=table[s]; dula=0; P0=0xff; wela=1; P0=0xf7; wela=0; delay(3); dula=1; P0=table1[g]; dula=0; P0=0xff; wela=1; P0=0xef; wela=0; delay(3); dula=1; P0=table[x]; dula=0; P0=0xff; wela=1; P0=0xdf; wela=0; delay(3); } void main() { uint i; dula=0; wela=0; while(1) { tem_change(); for(i=10;i0;i--) //每显示 71ms 后再启动温度转换命令，进行采样， dis_tem(get_data()); //避免了一直对温度数据采样，造成混乱 } }