CJ-46型自升式钻井平台18-3_4″防喷器组替代方案的可行性分析.pdfVIP

工程与施工 CJ-46 型自升式钻井平台18-3/4″防喷器组 替代方案的可行性分析 张福( 中海油田服务股份有限公司钻井事业部，天津 300452) 摘要：海上钻井平台的钻完井等作业由于地层中的不确定因素很多且十分复杂，钻完井等作业中的多个环节都有发生 井喷的可能性，这对井控技术和井控装备都提出了更高的要求。因此防喷器组作为海上钻井平台最重要的井控设备，它 的设计、使用、维护及检验都备受关注。CJ-46 型自升式钻井平台为国内新一代高端自升式钻井平台，平台出厂原始配 备防喷器组为美国NOV 厂家 18-3/4 ″×100 MPa。该尺寸和压力级别的防喷器组对于CJ-46 型钻井平台在渤海湾钻 完井作业中使用、维护及检验等方面所体现出的优势和局限性都客观存在，现就NOV 厂家 18-3/4 ″防喷器组在作业中 应用的局限性解决方案进行分析。尤其是在NOV 防喷器组在涉及配件更换及年度检验时，由于18-3/4 ″防喷器组的体 积庞大、重量较重、配件价格不菲且订购受限而带来的诸多困难，文章针对CJ-46 船型采用国产 13-5/8 ″防喷器组来替 代NOV 厂家 18-3/4 ″防喷器组的替换方案进行可行性分析和研究。 关键词：防喷器组更换；年度检验；替换方案 中图分类号：U674.381 文献标志码：A 文章编号：1008-4800(2022)06-0158-03 DOI:10.19900/j.cnki.ISSN1008-4800.2022.06.050 Feasibility Analysis of 18-3/4″ BOP Replacement for CJ-46 Jack-up Drilling Platform ZHANG Fu (Drilling Division, China Oilfield Services Co., Ltd., Tianjin 300452, China) Abstract: Due to many uncertain and complex factors in the drilling, blowout may occur in many links of offshore drilling platforms, which puts forward higher requirements for well control technology and well control equipment. Therefore, as the most important well control equipment of the offshore drilling platform, its design, use, maintenance and inspection have attracted much attention. CJ-46 jack-up drilling platform is a new generation of domestic high-end jack-up drilling platform, the platform factory original equipped with blowout preventer unit is American NOV manufacturer 18-3 / 4 ×100 MPa.The advantages and limitations of the blowout preventer group with this size and pressure level for the use, maintenance and inspection of CJ-46 drilling platform in Bohai Bay are objectively existing. Now, the limitation solutions of NOV manufacturer 18-3 / 4 blowout preventer stacks are analyzed. Especially when the NOV BOP group involves parts replacement and annual inspection, due to the large volume, heavy weight and limited or