A320_DMC2—检查主交流馈电控制工作M项20160505_5y811G_5y811G.pdf

--航线CBT考核教材 A320 DMC2—检查主交流 馈电控制工作M项 编写人：李鑫 日期：2014.6.23 Copyright Conserved by Training Management Department 一、准备工作 工具准备: 无. 警告牌准备: 探头加温跳开关. 人员资质： 技术员1名 参考文件： TASK 31-68-00-040-005-A 二、MEL内容 三、施工流程及要点 1. 操作测试AC Essential Generation Switching （AMM 24-25-00-710-001-A ） ① 确认跳开关闭合 ② 拔出探头加温跳开关 三、施工流程及要点 ③ 测试AC Essential-Generation Switching ACTION RESULT 1.On the ECAM control panel: On the ECAM DU, on the ELEC page: - Push the ELEC key. - A green line comes into view between the AC1 and AC ESS busbars. This shows that the AC1 busbar energizes the AC ESS busbar. 2.On the AC power center 123VU: On the F/O glareshield panel 130VU: - Open the circuit breaker 1XC. - The MASTER legend light of the F/O master-caution pushbutton switch comes on. On the CAPT glareshield panel 131VU: - If the CAUT legend light of the CAPT master-caution pushbutton switch comes on, ignore it. You can hear the single chime. The indications ELEC AC ESS BUS FAULT then AC ESS FEED... ALTN are shown on the ECAM DU. NOTE: During this test, the upper ECAM will be lost. If the lower ECAM is not serviceable (MEL conditi