0H2诊断spoto全球培训项目人才.pdfVIP

1、HSRPv6 Customer just setup a IPv work, with HSRPv6 on R1 R2. After setting up, all hosts lose connection. What would you recommend to your L1 Engineer as a Quick Fix? CE1 key configuration standby 1 priority 200 standby 1 preempt ipv6 nd router-preference low standby version 2 CE2 key configuration standby 1 preempt ipv6 nd router-preference high standby version 2 I think it is a rouge device because I dont see any problems with the HSRPv6 config. PCs are configured with ipv6 enable, ipv6 autoconfig The R1 have a ipv6 nd-preference high and R2 have low if Im not wrong. Q1 ：how fast fix the problem shut down interface of CE1 e0/0 1. Shutdown the link between CE2 and PE2 2. Shutdown the link between CE1 and PE1 3. configure CE1 with highest HSRPv6 priority 4. configure CE2 with low HSRPv6 priority 5. shut down interface of CE1 e0/0 6. Shutdown PE2 的 e0/0 7. Disable fastswitching on CE’s LAN 8. Enable fastswitching on CE’s LAN 9. Change HSRPv1 to HSRPv2(version) Q2:What is the root cause of the problem caused by the current ？ Which Device 1. Anwer ：High preference gateway information is sent out device ：Unknown device E’s LAN 1. Arp snoo 2. Routing Issue 3. Accesslist is blocking 4. Defaultgateway is link local address 5. High preference gateway information is sent out 6. HSRP device is (还是 with 有点忘了) High priority 7. Wrong HSRP configuration 8. Miss defaultgateway Device ？ 2. CE1 3. CE2 4. PE1 5. PE2 6. Host1 7. Host2 8. CE_DC 9. SERVER 10. Unknown device E’s LAN 11. Unknown device in MPLS 域 3. choose the first frame id that demonstrate your doubt A lot of captures lude ipv6 RAs, hsrpv2, icmpv6 destination unreachable. i filtered “HSRPv2” in Wireshark, then chose the first he CE1 state to active. Active: #227 。 Wireshark line:mine wa