基于模糊PID控制的电一气比例阀控制系统的研究的中期报告.docxVIP

基于模糊PID控制的电一气比例阀控制系统的研究的中期报告 Abstract: This report presents a study on the development and analysis of an electric-to-air proportional valve control system based on fuzzy PID control. The goal of the study is to develop a control system that can effectively regulate the flow of air through the valve by accurately controlling the electric current input. To accomplish this objective, the system makes use of a fuzzy PID controller that can adjust the current input based on the measured output. Introduction: The electric-to-air proportional valve control system is widely used to regulate the flow of air through a valve. The system comprises an electric current input that controls the opening and closing of the valve, an air flow input that regulates the amount of air flowing through the valve, and an output that monitors the valves position. The objective of this study is to develop a control system that can accurately and effectively regulate the flow of air through the valve. To achieve this objective, a fuzzy PID controller is utilized that can adjust the electric current input based on the output of the system. Methodology: The proposed system consists of an electric-to-air proportional valve, a current feedback circuit, an air flow sensor, a microcontroller, and a fuzzy PID controller. The current feedback circuit is connected to the electric-to-air proportional valve to measure the current input, while the air flow sensor is connected to monitor the flow of air through the valve. The fuzzy PID controller is designed to adjust the electric current input based on the error between the desired and actual air flow rates. The fuzzy logic system comprises three inputs, namely the error, error rate, and accumulated error, and a single output that controls the current input. The system uses the Mamdani inference system to adjust the output based on the inputs. Results: The preliminary results of the study demonstrate that the fuzzy PID controller can effectively regulate