Danfoss丹佛斯Series 90 CPRV Adjustment Installation Guide 安装指南.pdf

Genuine Parts CHARGE PRESSURE The following procedure explains how to checkand adjust the charge pressure relief RELIEF VALVE valve. ADJUSTMENT 1， Install a 50 bar [1000 psi] pressure gauge in the Pump charge pressure gauge port 全 Warning (M3).Install a 10 bar [100 psil gauge to measure case pressure (tee into L1 orL2 or The following procedure use servo gauge port M4 or M5).Operate the system with the pump in neutral (zero may require the vehicle/ displacement) when measuring pump charge pressure. machine to be disabled (wheels raised off the 2，Thetable shows the acceptable pump charge pressure range for some charge relief ground,workfunction valve settings.These pressures assume 1500 min (rpm) and a reservoir temperature disconnected etc.J) in order of 50*C [120?*F],and are referenced to case pressure. to prevent injury to the technician and bystanders. Take necessary Safety Charge pressure relief valve precautions before moving Case drain port L1 the vehicle/machine. 加 。obarmo-ioopsn 11716-12 图 115 Nm [85 1Ibf-f Charge pressure gauge port M3 | 四 | 0-50barI0-1000 psi] 9/16-18 [ 回 23 Nm [17 Ilbf-f]