【精品】lab7.pdfVIP

Filter Design Multi-Rate Systems Introduction In this lab you will be using the Filter Compiler block to generate optimized filters for the Virtex4 architecture. Note: There is a completed example in lab7/solutions folder Objectives After completing this lab, you will be able to: • How to use the FIR Compiler to generate various filter implementations • How to use the Mathworks FDA tool to generate and set the filter coefficients Lab Setup The following software is required to be installed on your system to successfully complete this lab 1. System Generator 8.2 2. ISE 8.2.01 3. ISE CORE Generator IP Update 1 4. MATLAB / Simulink R2006a 5. Simulink Signal Processing Blockset Creating a 12 x 8 MAC 05b-3 Using the Xilinx System Generator 1-877-XLX-CLAS Procedure 1. Launch the MATLAB program and once invoked change directory to: C:\SysGen_Training_Labs\lab7 2. Open up the Simulink diagram “lab7.mdl” shown in Figure 1. Figure 1 – Simulink Filter Model 3. Double click on the FDATool icon. FDATool is a graphical filter design program provided by The Mathworks. It can be used to generate filter models for both MATLAB and Simulink and, in this case, is integrated into the actual Simulink filter model. This has been configured to generate coefficients for a 16 tap, filter FIR filter. Figure 2 – The Mathworks FDATool 4. Click on “Design Filter” to generate the filter specified by the FDATool parameters. 5. Close FDATool and simulate the filter design in Simulink. Set the Simulation time to “in