年产7万辆轻型车驾驶室电泳涂装车间设计.doc

ABSTRACT Along with the development of the car coating technology and the requirements of environmental protection, and gradually improve domestic car coating line already pay more and more attention to environmental protection energy-saving coating new materials and new technology application. Design car coating line, and the working principle of coating equipment and parameters to match; At the same time, in order to pursue the painting line of high the lean and high flexibility, equipment selection should be used as much as possible through strengthening the domestic equipment, equipment maintenance to improve the whole production line to start the rate, so as to reduce the production line the construction cost; To fully understand and forecast the development of the new models, the new painting line should be able to meet the many varieties of production line, make the subsequent models on the production line production line transformation possible time. Now, according to the requirements of the design task, design with an annual output of 70000 cars of ordinary car electrophoresis painting workshop, choose the typical cathodic electrophoretic coating process. Process selected, according to the technology and years of production program requirements, design and calculation of the process. Process design including process flow, the process used to determine the technological standard, etc. Selection and calculation of the treatment process to the size and number of slot, the choice of the main equipment needed workshop. Finally the design of content of regeneration. Keywords: electrophoresis painting；coating process；electrophoresis groove；workshop design；electrophoresis equipments  摘要………………………………………………………………………………………… Ⅰ ABSTRACT……………………………………………………………………………………………II 1绪论…………………………………………………………………………………………1 2电泳涂装……………………………………………………………………………………2 2.1电泳涂装的发展概况………………………………………………………………2 2.2什么是电泳涂装……………………………………………………………………2 2.2.1电泳涂装的定义…………………………………………………………………2 2