毕业论文：电阻电容电感测试仪.doc

12届 　 分 类 号: 　　　　　　　　　　　　　　　　　 单位代码:10452 临沂大学理学院 毕业论文（设计） 电阻电容电感测试仪 　　　　　　 姓 名　 　　　 王 金 全　　　　　 　　　　　　 学 号　　　摘 要 本文介绍了一种产生高精度的正弦波信号流经待测的电容或者电感和标准电阻的串连电路,通过测量电容或者电感和标准电阻各自的电压,利用电压比例计算的方法推算出电容值或者电感值本设计利用单片机控制测量和计算结果,采用1602液晶模块实时显示数值实验测试结果表明,本设计性能稳定,测量精度高1602液晶模块 ABSTRACT The paper introduced the design of a microcontroller (89C51)-based high-precision resistor inductance capacitance measuring instruments. This design uses MAX038 monolithic voltage-controlled function generator to produce high-precision sine wave signal through the test of the capacitance or inductance, and the standard resistance series circuit, figure out by measuring the capacitance or inductance, and the standard resistance of the respective voltage, using the method of calculation of the voltage ratio of the capacitance or inductance value. This design uses 51 microcontroller to control the measurement and calculation results, the 1602 LCD modules real-time display values ??include sinusoidal signal generator, the standard resistance and inductance or capacitance in series voltage divider circuit, multi-channel switch, voltage follower, high-precision AC /Converts the value of the chip, the A / D conversion chip, microcontroller, display module, keyboard module, and other parts, with manual adjustment range by a single-chip automatic detection analysis to identify the original nature of the image through the LCD display, the sinusoidal signal generator can be achieved amplitude andfrequency adjustment, in order to improve the accuracy of the measured AC voltage through the ICL7650 and to eliminate the error caused by the AD637 input resistance lower. experimental test results show that this design, stable performance, high measurement accuracy. Key words: the voltage ratio method; 89C51; ad637; resistor inductance capacitance measurement; 1602 LCD module 目 录 1 引言 1 2 电压比例法测量原理 1 3 系统方案 2 3.1系统总体方案设计与结构框图 2 3.2方案设计与论证 3 4