单击片毕业设计论文智能红外测温计的设计.docVIP

摘要 传统的温度计多采用物理原理，根据水银等随温度升降的热胀冷缩的性质，通过读取刻度值来判断温度值，这种方法不太方便，且测量需要的时间较长。本项目提供一种新的温度测量方案，采用具有SPI（Serial Peripheral Interface 串行外围接口）接口的TN系列红外温度传感器来测量温度信号，可同时测量目标温度和环境温度，并将测量的数据送给SPCE061A单片机SPCE061A单片机关键词：红外测温SPCE061A单片机；语音播报 A Design of Intelligent Infrared Thermometer Abstract Most of the traditional thermometers adopts mercury column which has the physical principle that it expands with heat and contracts with cold along with the change of temperature, and we can read the temperature out according to the infinity. This method is not convenient, and it takes a long time to measure. This paper proposes a new thermometer project to measure the temperature signal by using the TN series infrared temperature sensor which has the SPI (Serial Peripheral Interface). The sensor can measure both the target temperature and environment temperature at the same time, meanwhile the temperature data which have been measured can be transferred to the SPCE061A microcontroller to process. Then, the data will be transferred to data display, and will be reported by using the SPCE061A’s voice report function in the meanwhile. Infrared thermometer breaks through traditional temperature measurement pattern. It responses quickly, and has high accuracy and high reliability and measures in large area. It is also a way of non-contact measurement, so it isn’t easy to break. This thermometer can measure accurately and quickly, and has the clear and easy display. All these offer convenient condition to our daily life. Furthermore, the voice report function makes it more intelligent and human. Key words: infrared thermometry; SPCE061A microcontroller; voice report 目 录 1 前言 1 1.1 选题的目的和意义 1 1.2 红外测温技术的发展和国内外研究概况 1 1.3 设计任务和要求 3 1.3.1 设计任务 3 1.3.2 设计要求 3 2 概述 4 2.1 红外测温概况 4 2.1.1 红外测温的基础理论 4 2.1.2 红外测温的特点 7 2.2 智能化测量仪表概述 7 2.2.1 智能化测量仪表的基本组成及其发展 8 2.2.2 智能化测量仪表的设计方法 9 3 系统方案论证 11 3.1 任务分析 11 3.2 方案选择 11 3.2.1 方案一 11 3.2.2 方案二 11 3.3 系统工作原理 12 4 系统硬件设计 14 4.1 主控模块 14 4.1.1 SPCE061A简介 14 4.1.2 SPCE0