《电压型三相交流变频调速系统的设计》.doc

电压型三相交流变频调速系统的设计 PAGE  PAGE 52 电压型三相交流变频调速系统设计 摘要：本课题主要是研究电压型三相交流SPWM变频技术的基本原理、实现方法及软硬件设计，完成系统的软硬件设计。要求完成内容主要有：1、变频调速技术基本原理2、变频调速基本原理3、控制方案确定4、软件与硬件设计5、实验调试。涉及的主要相关知识：电力电子及运动控制、微机控制。在通常情况下交流异步电动机用作调速机时，它的控制电路复杂，系统的效率较低。采用单片机微机控制的交流异步电动机变频调速系统使起控制电路大为简化，使用正弦脉宽调制（SPWM）驱动，系统效率也有所提高。 交流异步电动机的变频调速，实际中多采用脉冲宽度调制（PWM），完成调频和调压两种功能。用单片微机实现（PWM）来控制可使调节灵活，电路简化。本设计采用的MCS51系列的单片微机控制PWM，在300W的二相异步交流电机上进行运行实验。 传统的交流变频调速系统由正弦波和锯齿波相交产生所需的脉宽调制波实现恒压额比的变频调速控制。这种系统由于采用模拟控制，设备复杂、调整困难，且控制精度低，可靠性差，因而限制了这种系统的应用。与上述传统的系统相比，本系统具有如下特点：采用新型大规模专用集成电路产生脉宽调制波，使波形稳定，精度和可靠性显著增加。以单片机8031CPU为核心的全数字控制．电路简单，调整迅速，进一步提高了控制精度。 关键词：电压型三相PWM整流器，变频调速，单片机，交流电机； Design of three-phase Voltage-type Inverter Control System ABSTRACT： Focus is Studying SPWM three-phase voltage-type AC inverter with the fundamental principles in this paper, and designing the methods and software and hardware, and complete system software and hardware. The main completion on: 1.the basic principles of VVVF technology 2. three basic principles of Frequency Control, the control scheme for the 4, 5 software and hardware design, experimental debugging. The main relevant knowledge: power electronics and motion control, computer control. Under normal circumstances in exchange for motor asynchronous speed machine, its complicated control circuits, the systems efficiency is low. SCM using computer control the exchange of asynchronous motor Frequency Control System that has greatly simplified control circuit, the use of SPWM (SPWM) drive, the system has improved efficiency.  Induction Motor Frequency Control, in the actual use of pulse width modulation (PWM), and completed FM Surge two functions. To achieve single-chip microprocessor (PWM) to control can adjust flexibly, to simplify circuit. This design by the MCS51 series of single-chip microprocessor achives PWM control, 300W in the two-phase asynchronous motor exchanges on running the experiment. The traditional exchange of Frequency Control System from the intersection of a s