《希尔顿酒店设计标准第24节垃圾收集区》.docVIP

第24 节 垃圾收集区 24a. TRASH COMPACTOR / CONTAINER 垃圾压实机/垃圾箱 24b. REFRIGERATED TRASH ROOM 垃圾冷库 24c. RECYCLABLE STORAGE ROOOM 可回收物储藏室 CAN WASH 24d. 洗罐区 第24a 节 垃圾压实机/垃圾箱 24a-1.00 GENERAL 24a-1.00 总则 24a-1.01 Provide self-contained compactor/container. 提供自给型压实机/垃圾箱。 24a-1.02 The charging point of the trash compactor must be accessible directly from the receiving dock. 垃圾压实机的进料口必须可从收货台直接抵达。 24a-1.03 Locate the compactor at the end of the dock nearest to the kitchen. 将压实机放在距离厨房最近的卸货车位的末端。 24a-1.04 Provide a minimum 20-yard (15M3) compactor/container. Trash removal costs are generally calculated by the frequency of removal, so the largest practical trash container should always be used. 至少应采用20 码（15 立方米）的压实机/垃圾箱。清除垃圾的费用通常根据清除频率来计算，因此应始终使用最大的垃圾箱。 24a-1.05 Verify the horizontal and vertical clearances for the removal of the trash compactor/container with unit supplier. Vertical clearance of 18 (5.4m) to 20 feet (6m) is commonly required. 与设备供应商一起确认移动垃圾压实机/垃圾箱所需的水平和垂直净空。通常需要的垂直净空为5.4 米到6 米。 24a-1.06 Install the compactor on a concrete slab and pitch toward a separate sanitary drain. 将压实机安装在一个混凝土板上，并朝着一个单独的排水管倾斜。 24a-1.07 Provide guard rails at dock adjacent to the compactor/container. 在与压实机/垃圾箱相邻的卸货车位提供护栏。 24a-1.08 Trash chutes are not allowed. 不得使用垃圾竖井。 24a-2.00 DOORS, WINDOWS, and HARDWARE 24a-2.00 门、窗和五金件 24a-2.01 Provide a 3‘-6‖ x 6‘-8‖ (1m x 2m) door to the compactor/container area from trash rooms. 为垃圾间内的压实机/垃圾箱区提供尺寸为1 米 x 2 米的门。 24a-3.00 FINISHES 24a-3.00 饰面 TRASH COMPACTOR/CONTAINER AREA: 垃圾压实机/垃圾箱： Floors - Concrete, steel troweled and sealed or better 地面 - 混凝土抹面做面层或者更佳材料 Walls - Epoxy paint or better 墙面 - 环氧树脂涂料或者更佳材料 24a-4.00 F F E (NA) 24a-4.00 家具、固定装置和设备（不适用） 24a-5.00 SPECIAL CONSTRUCTION (Graphics and Signs) (NA) 24a-5.00 特殊结构（图形和标志）（不适用） 24a-6.00 MECHANICAL/PLUMBING 24a-6.00 机械/管道 24a-6.01 Locate a self-priming sanitary drain beneath the compactor. Position the drain near one end of the compactor area so that it is accessible when the compactor/container is in pla