离心泵电阻点焊叶轮有限元分析.pdf

期 离心泵电阻点焊叶轮有限元分析* 王洋 王洪玉 王维军 （江苏大学流体机械工程技术研究中心 镇江 212013 ） 摘要：为准确计算电阻点焊叶轮在流场中的应力及变形情况，借助多物理场协同仿真平台 ANSYS Workbench，采用单向流固 耦合方法对电阻点焊叶轮进行有限元分析。首先对叶轮有限元模型的网格无关性进行分析。在此基础上，计算了叶轮在设计 工况下的等效应力及变形情况，并分析了叶轮最大等效应力及最大总变形随流量的变化情况。计算结果为电阻点焊叶轮结构 设计及优化提供有效依据。 关键词：离心泵 电阻点焊叶轮 流固耦合 有限元分析 中图分类号：TH311 Finite Element Analysis for Resistance Spot Welded Impeller of Centrifugal Pump WANG Yang W ANG Hongyu W ANG Weijun （Technical and Research Center of Fluid Machinery Engineering, Jiangsu University, Zhenjiang 212013 ） Abstract ：To accurately calculate stress and deformation of the resistance spot welded impeller in the flow field, the finite analysis for the impeller was carried out by means of th e co-simulation platform ANSYS Workbench used for th e multi-physical fields, with one-way fluid structure interaction method. Firstly, the sensitivity of the finite element analysis models of the impeller on d ifferent mesh density was analy zed. Then, the equivalent (von-Mises) stress and to tal deformation of the impeller at the design f low rate condition were calculated. Moreover th e characteristic of the maximum stress and total deformation at d ifferent flow ra tes was investigated. The results provide effective references to the structural design and optimization for the resistance spot welded impeller. Key words ：Centrifugal pump Resistance spot welded impeller Fluid structure interaction (FSI) finite element analysis 目前对于离心泵叶轮强度的计算大多基于经验 0 前言