不同干燥方法合成六铝酸盐催化剂及其性能的研究.pdfVIP

  • 17
  • 0
  • 约3.96万字
  • 约 31页
  • 2017-09-22 发布于北京
  • 举报

不同干燥方法合成六铝酸盐催化剂及其性能的研究.pdf

不同干燥方法合成六铝酸盐催化剂及其性能的研究 摘 要 甲烷催化燃烧是节能环保的清洁燃烧技术。甲烷与空气进行混合后,均匀通过 催化床层,在活性粒子的催化作用下实现完全氧化反应。甲烷催化燃烧可在很低的 浓度下(4%)稳定进行,而且燃烧温度低于1200℃,从而大大降低了氮氧化合物 (NOx )和CO的形成,起到保护环境和提高资源利用率的作用。本文以反相微乳 液-醇盐水解结合的方法制备了系列单相金属(M为一种金属)掺杂和复合金属(M 为两种或两种以上金属)掺杂的六铝酸镧(LaM Al O )催化剂。采用XRD进 x 12-x 19 行了物理性质表征,并以甲烷催化燃烧为目标反应研究了催化剂性能与掺杂元素种 类之间的关系,并深入研究了不同干燥方法对最终产品的影响。结果表明:经过1200 ℃焙烧4h后,催化剂主要以六铝酸盐晶相存在,离子的取代在不同程度上提高了六 铝酸盐的结晶度,促进了六铝酸盐的生成;单金属Mn 的存在可以降低甲烷的起燃 温度,使催化剂具有良好的低温活性,单金属Fe掺杂的六铝酸镧催化剂具有较低的 完全转化温度;而Fe 、Mn共同掺杂形成的LaMnFeAl10O19催化剂具有优越的低、高 温活性和高温稳定性。用冷冻干燥的方法制得的样品比普通干燥制得的样品晶体成 形情况更好。 关键词:反相微乳液,醇盐水解,六铝酸盐,甲烷,催化燃烧 I 不同干燥方法合成六铝酸盐催化剂及其性能的研究 Abstract The catalytic combustion of methane is an energy-saving environmental friendly technology. After methane mix with air,put them through the catalytic bed uniformly, they will take complete oxidation reactions under the catalytic of active particle. The catalytic combustion of methane can take place steadily at very low concentration( 4%) . And the combustion temperature is below 1200 ℃ ,which can effectively reduce the emissions of CO and NOx. It’s a protection of the environment and enhance the role of resource utilization. In this paper, the hexaaluminate catalysts were synthesized by the method of reverse microemulsion and alcohol saline solution conbine together. The alkoxides of LaM Al O catalysts were substituted of by single x 12-x 19 metallic element or complex metallic element which composed with two or more metallic ele

文档评论(0)

1亿VIP精品文档

相关文档