DEK高级培训资料.ppt

Rising Table (Berger Lahr) Calibration Summary Calibrations Summary Calibrations required if Config.cfg was deleted or corrupt: Vision Height Print Height Board stop X Offset Camera Reference Position Vision Scale Calibration Vision Offset Calibration Squeegee Reference Heights plus other settings such as cleaner type etc Vision Height Set in diagnostics Saved to configuration file (config.cfg) Rising table position to allow camera to capture board fiducials... Home position Vision height Reference print height Home position Set in diagnostics Saved to configuration file (config.cfg) Rising table position to place board in contact with stencil for printing. Note: Set without board, then when printing, board thickness is taken into account…. Print Height Carried out in diagnostics Entered in Set Prefers Saved to configuration file (config.cfg) Carried out when a camera is replaced Distance measured from centre of optics to board stop assembly ... Board Stop X offset Set in diagnostics Saved to configuration file (config.cfg) Point from which all camera positions are measured ... Camera Reference Offset calibration 2mm 2mm Vision calibration Carried out in Maintenance /Calibrate Vision Saved to configuration file (config.cfg) Calculates scaling factor, centre of rotation of stencil, fiducial capture and ‘x’ and ‘y’ offsets of camera system ... Vision and Offset Calibrations Screen Alignment Transport Rails The transport rail module consists of the following sub-assemblies: Front and rear rails Rail width stepper motor Dual stepper drive card (X3) Transport belts Belt drive DC motors Board clamps Board clamp regulator 4 x Gas dampers 2 x Clatter bars Moving rail home sensor Board at left and right sensors Rail lifted left and right sensors Transport Rails Tasks Remove and replace rail width drive belt Measure and adjust front and rear rail parallelism Measure and adjust board clamp parallelism Adjust guide board edges Perform rail to table height adjustment With ne