日处理2000吨污水生物接触氧化法.doc

摘要 本设计内容是山东兖州矿业集团杨村煤矿区2000吨/日生活污水处理厂初步设计。根据杨村煤矿区生活污水的水质特点，经技术和经济等方面的对比，采用生物接触氧化工艺。 生物接触氧化是采用生物膜水处理废水的一种方法,是以附着在载体（填料）上的生物膜，净化有机废水的一种高效水处理工艺其中设计要完成设计说明书一份，污水处理厂总平面图一张，污水处理厂污水高程图一张，工艺流程图一张，及张单个处理构筑物平面图，剖面图的设计图污水处理厂出水要达到国家(GB8978)中二级排放标准的规定。所选的工艺具有工艺稳定性高，处理构筑物少，流程简化，节省投资等优点。  Abstract This design is the primary design of Shandong Yanzhou Mining Group Yangcun Coal Mining Area 2000 tons / day sewage treatment plants . Biological contact oxidation process was used based on the sewage quality characteristics of the Yangcun coal mining area and the technical and economic comparison. Biological contact oxidation biofilm is a kind of wastewater treatment method, which is a highly efficient wastewater treatment process of organic materials purification with the biomembrane attached to the carrier (commonly known as fillers).The main content of the design including the purpose and requirements of the design, building conditions and process selection, design and calculation of sewage structures, engineering economic analysis and environmental impact assessment. Which design to complete the design of a manual, a general layout of the sewage treatment plant, sewage treatment plant sewage elevation map a process flow diagram one, and four single treatment tank plan, profile design.Sewage treatment plant effluent to achieve national "Integrated Wastewater Discharge Standard (GB8978) the provisions of the two emission standards. Selected biological contact oxidation process has some advantages, such as high process stability , less structure, process simplification and saving investment. Key words: Biological contact oxidation Biomembrane Domestic sewage in coal mine area 目录 摘要 I Abstract II 第1章 设计概论 1 1.1任务的提出 1 1.2要求 2 1.3设计基础资料 2 第2章 建设条件与工艺流程的确定 4 2.1 厂址的选择 4 2.2 建设条件 4 2.2.1地理位置 4 2.2.2气候条件 4 2.2.3地形地貌 5 2.3设计方案及可行性分析 5 2.3.1 SBR工艺 6 2.3.2 生物接触氧化工艺 7 2.3.3 工艺比选 8 2.3.4 工程实例 9 2.4 工艺的确定 13 2.4.1生物接触氧化法工艺流程图 13 2.4.2工艺流程简述 13 第3章污水处理构筑物设计计算 14