家用防盗报警器的设计.docVIP

南京信息职业技术学院 毕业设计论文 作者 学号 系部 电子信息学院 专业 无线电专业 题目 家用防盗报警器的设计 指导教师 评阅教师 完成时间： 毕业设计(论文)中文摘要 (题目)：家用防盗报警器的设计 摘要：现时社会治安问题严峻，各种入室抢劫、偷盗事件时有发生，治安问题更加突出。为了防护自己，越来越多的家庭采用智能防盗报警产品。防盗报警系统是利用探测器装置对建筑物内外重点地点和区域进行布防，探测。当探测器探测到非法入侵，报警器工作状态变为报警状态，产生报警声，并显示出事位置。本红外线发射电路都是采用脉冲调制式，红外接收电路首先将接收到的红外光转换为电信号，并进行放大和解调出用于无线发射电路的调制信号。当无人遮挡红外光时，锁相环输出低电平，报警处于监控状态；一旦有人闯入便遮挡了红外光，则锁相环失效，输出高电平，驱动继电器接通无线发射电路，监控室便可接收到无线报警信号，并可区分报警地点。本系统以AT89C51单片机为核心，主要由红外遥控发射器和AT89C51单片机控制的红外接收电路以及报警输入检测电路、输出控制电路构成。 关键词：锁相环；红外遥控发射器；AT89C51单片机 毕业设计(论文)外文摘要 Title : Household anti-theft alarm system design Abstract: Current social security problem is severe, all sorts of home invasion robbery, theft incidents, public security problem become more prominent. In order to defend themselves, more and more families to use intelligent anti-theft alarm products. Anti-theft alarm system is to use of buildings on the probe device inside area of protection, place and detection. When the probe detected illegal invasion, alarm working state into alarm condition, produce alarm sound, and display the crash position. The infrared emission circuit are using pulse adjustable type, infrared receiving circuit will first receives the infrared signal, and converting amplification reconciliation for wireless transmitting circuit accesses the modulation signal. When no one block infrared, and phase lock loop output low level, alarm in monitoring state; Once someone broke into then blocked infrared, criterion and phase lock loop failure, the output level, drive relay through high launch circuit, monitoring room wireless will receive wireless alarm signal, and can distinguish alarm site. This system to AT89C51, mainly consists of infrared remote tran