槽盒施工方案.docVIP

General 1.1BASF-YPC company Ltd IPS project IOU SCTF, the scope of instrument trays installation: diagrams main piping frame 、diagrams pipe rack etc. 1.2Instrument trays 800*200, quantity 540 m The specification of channel steel supports: 800 mm , quantity 540m 1.3The quantity of the other instrument trays 1500m 2.0Construction basis 2.1Yang Zi Petrochemical Design Institute, drawing list:70-00-00 2.2Code for construction and acceptance of automation instrumentation engineering GB50093-2002 2.3Standard for quality verification evaluate of automation instrumentation engineering GBJ131-90 2.4 Technical code of construction of instrumentation engineering for petrochemical industry. SH3521-19999 3.0 Technology demand and measure. 3.1Acoroding with the instrument trays layout drawing, compile the instrument construction measure. 3.2Before the construction, have the technology clarification and the work indication, confirm the relative prescriptions of the technology demand and the construction specification. 3.3Speciality joins, pay attention to speciality joins and the crisscross distance of all kinds of relative speciality duing the construction. 3.4 The cable trays fabrication specification is accord with the design’s demand, properly select material, combine, weld burnish, rust remove and pain. 3.5When the main cable trays are installed, the installation location shall be accord with the trays layout drawing, and use the M8*30 galvanizing bolt to connect with the frame. 3.6Before installing the main trays, inspect that the specification and type shall be conformed to the demand of the design, good semblance and rustless phenomenon. 3.7The main instrument trays are lay on the channel steel support, use 30*30*4 angel steel welding the channel steel sides, so that secure the instrument trays. 3.8When all the main instrument trays have been installed, after integrated inspecting qualified with IMT, the next work shall be carried out. 3.9For the widely layout, the breach