10吨位桥式起重机的总体设计.doc

摘 要 Abstract After more than ten years of development, the industrialization of China has continuously promoted, and the crane industry demands further increase.Overhead travelling crane is the main type of overhead type crane and it has the following advantages: high field utilization rate,greater scope of work, wide range adaption,good universality and so on. In general,overhead travelling crane is composed of srane span structure,hoisting mechanism ,wheeling mechanism,travelling mechanism of the larger traveller ,control carbin,the car conductive device,the general supply conductive device of srane etc.This design uses the electric double girder overhead travelling crane research. The full text is divided into 5 parts to complete this design topic content: The first part is the preface.In this part,the effect of crane, the development of the situation and existing problems of lifting equipment at home and abroad,the development direction of China will be introduced. The second part is the determination of the overall layout of the structure.This part mainly analyzes the work characteristics and technical parameters of the crane.The constiturnt part of layout scheme include hoisting mechanism , wheeling mechanism,travelling mechanism of the larger traveller and calculation of wheel pressure will also be mentioned.This part include The third part is the design of the bridge structure.It includes the main dimensions of overhead travelling crane such as the wheelbase of cart,height of main beam,end beam heigt,layout size of the stiffened plate and so on. We will consider the checking of calculating load,box structure beam and main weid. The fourth part is the design of electrical part.The fundamental and development status of frequency control will be talked about. Overhead travelling crane，hoisting mechanism，cart and trolley all need consider frequency control.There is a design of global PLC. In the last part ,according to the conclusion,the paper has made