外文翻译-变速箱各档齿轮基本参数的选择.docVIP

附录： THE FILE TRANSMISSION GEAR SELECTION OF THE BASIC PARAMETERS 1, Reasonable choice of module: Modulus is an important gear basic parameters, the greater the modulus, the greater the tooth thickness, the bending strength of gear is also greater, and its greater carrying capacity. Instead modulus smaller tooth thickness will be thinner, the bending strength of gear will be smaller. The low profile of the gear, due to the low rotational speed, torque, and gear of the relatively large bending stress, so need to choose a larger module in order to ensure its strength. And high-speed file gear, due to the high-speed, torque small gear bending stress is relatively small, so to ensure that the bending strength of gear under the premise of the general selection of the smaller module, so that gear teeth can be increased in order to obtain larger degree of overlap, so as to achieve the purpose of reducing noise. In a modern gearbox design, the file selection module gear is different. For example, a transmission gear of a file to the five-gear gear module are: 3.5; 3; 2.75; 2.5; 2; to change over the past modulus or modulus of the same can not be the situation of Latin America. 2, a reasonable selection of pressure angle: When a gear module and set the number of teeth, the gear diameter is determined, and the gear tooth involute base circle depends on the size, the size of the base circle and under pressure angle. For the same pitch circle of gear, if its pitch circle a different pressure angle, base circle is different. When the greater the pressure angle, the base circle diameter of the smaller, more curved involute, tooth root of the tooth will thicken, increase the tooth surface radius of curvature, which can increase the tooth bending strength and contact strength. When reducing the pressure angle, the base will become larger diameter, involute tooth profile will change some of the straight, thinning of the tooth root, tooth smaller radius of curvature, making the tooth